What are the Whirlpool error codes?
Front Load Washer Error Code Guide For Select Whirlpool Washers
| Error Code | Error |
|---|---|
| Sud or Sd | Suds error: There are too many suds in the washing machine |
| F5 E2 | The door is not locking properly |
| F7 E1 | Indicates an error sensing motor speed |
| F8 E1 or LO FL | The washer is sensing low water pressure |
How do you clear a washing machine error?
Reset your washing machine What you can do instead is power cycle it: Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the washer (usually 1 to 5 minutes at most), and then power it up again. This is the closest you can get to a “reset” of the washer.
How do I fix E01 f09 Whirlpool?
Unresponsive Central Control Unit (CCU)
- Disconnect the washer’s power cord and wait for a couple of seconds.
- Remove the top panel.
- Locate the CCU and unplug it.
- Replace the CCU with a new one.
- Reinstall the top panel and any other parts you disassembled.
- Run a Quick Diagnostic Test to ensure that everything went as expected.
What does E01 and F06 mean on a Whirlpool washer?
A Whirlpool washer error code E01/F06 indicates that the washer’s motor control unit (MCU) is having trouble communicating with the washer’s central control unit (CCU). In most cases, the issue is caused by a damaged MCU circuit, usually caused by an overload.
How do you clear the code on a whirlpool F9?
F9 – Oven Door Lock Failure – Check door lock switches and wiring. Check for stuck lock switch. FH – Detects No Water Entering Machine or No Pressure Switch Trip – Select ‘cancel’ twice to clear this code.
What does F05 mean on Whirlpool washing machine?
If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the F05 error code will be displayed. Replace failed component. The control is unable to properly detect motor speed and the machine will shut down.
How do I clear the error code on my Whirlpool washer?
System error code. Press POWER to cancel cycle and clear the code. Then press POWER and select DRAIN & SPIN if there is excessive water in the washer. If the code appears again, call for service. Excessive suds in washer. Washer is running a suds reduction routine. Allow the machine to continue. Use only HE detergent.
How do I fix the F05 error on my Kenmore washer?
• Check the electrical connections at the pump and make sure the pump is running. If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the F05 error code will be displayed. Replace failed component.
What are the fault codes for Whirlpool appliances?
Whirlpool Fault Codes F1 – E2 UL A/D error (s) F1 – E4 Model ID error F1 – E5 Calibration shifted F1 – E6 Latch signal mismatch error