How do I read my VW ABS code?

Connect your VW scanner and turn on the ignition but do not start the engine. Turn on your scanner and select Volkswagen and then your particular model. Next, go to control units and select the ABS control unit or brake control unit, depending on the scanner. Scroll down to Read DTC or read fault codes.

How do I reset my VW ABS?

Resetting Your ABS Dashboard Warning Light Step One: Disconnect the positive cable from your car battery. Then, hold down the brake pedal to drain the vehicle’s electrical system. This will result in a reset of the car’s central computer. Plug the cable back in to restore power.

How do you test an ABS actuator?

How To Diagnose A Failing ABS Actuator In 6 Easy Steps

1. Open the hood and locate the ABS actuator.
2. Clean off the terminals on the ABS actuator.
3. Start the engine.
4. Connect the ohmmeter ground wire to the top terminal.
5. Check the reading on the ohmmeter.
6. Repeat with all the other terminals on the ABS actuator.

How do I disable my ABS system?

If you ever have to disable your ABS system, the relay is the most direct and effective way to handle it.

1. Pop your hood and remove your negative battery cable.
2. Locate your main relay box.
3. Open the relay panel and examine the diagram printed on the inside of the cover.
4. Replace your negative battery cable.

What happens when the ABS control module fails?

So, when an ABS control module fails, you’ll likely notice it when you’re braking heavily. A bad ABS module can behave erratically, making your brakes lock up even under normal braking. You might even notice unusual behavior from the brakes, like random clicking noises. These can also indicate ABS module failure.

How to fix VW 01276 ABS Hydraulic Pump V64?

VW 01276 ABS Hydraulic Pump V64 Repair: 1 Use ODIS diagnostic software perform trouble code reading,got 01276:ABS hydraulic pump v64 faulty. 2 Disconnect the ABS module connectors 3 Check V64 pump power source 4 Disassemble the V64 control unit PCB,mechanic found cold solder joint 5 Resolder the cold solder joint.

What are the error codes for the ABS Hydraulic Pump?

01276-014 – ABS Hydraulic Pump (V64) Defective – Intermittent. 01276-012 – ABS Hydraulic Pump (V64) Electrical Fault in Circuit – Intermittent.

What does the code 01276-014 mean?

I just got the 01276 but with a “014 – I did just recently have to clean one of my green fuses on the battery tray because my AC didn’t want to run the other day. This time I swapped the fuse with a different one, likely the ABS one. 01276-014 – ABS Hydraulic Pump (V64) Defective – Intermittent.

What are the codes for a V64 hydraulic pump?

01276-014 – ABS Hydraulic Pump (V64) Defective – Intermittent. 01276-012 – ABS Hydraulic Pump (V64) Electrical Fault in Circuit – Intermittent. The only real problem was low voltage supply.