What causes a Sloan flush valve to keep running?
Flushometer Continuously Runs/ Valve Will Not Shut Off This occurs when a control stop does not open all the way when the unit is flushed, which then causes the water pressure to not be high enough for the diaphragm to function properly and reset. This causes water to continuously run into the unit.
Why is my flush valve not working?
Check the lift chain and make sure it’s properly attached to the lift arm and the flapper at the base of the flush valve. Untangle or adjust as needed. Make sure the flapper seals the flush valve opening. If the flapper is damaged or warped, replace it.
What causes toilet to keep running after flushing?
Incorrect Water Level When the water level in your toilet is too high, the residual water will keep draining into the overflow tube. This causes the toilet to keep running after a flush, potentially instigating water damage in the long run. To correct the water level, you will need to lower the toilet float.
How to rebuild a Sloan flush valve?
Solution: Open control stop or main valve. Cause: Handle assembly is worn. Solution: Install Sloan handle repair kit (B-50-A) or replace handle. Cause: Relief valve is worn. Solution: Replace inside parts kit. Problem: Insufficient volume of water to adequately siphon fixture. Cause: Control stop not open enough.
How to rebuild a Sloan Valve stop?
Sloan control stop repair kit
How to fix Sloan Regal and Royal flushometer valves?
Insert a screwdriver in the water control stop screw on the right side of the flush valve.
How to shut off a toilet valve?
Look for the valve in the basement if you live in a colder climate.