What is a locking clip on car seat?

The locking clip is a pre-crash positioning device. It is designed to hold the seat belt tight up to the moment of impact in a crash when the emergency locking retractor of the shoulder belt takes over.

Table of Contents

What is the red clip on booster seat?

It is called a shoulder belt positioning clip and is used to keep the shoulder belt at the correct position when using a backless booster. The fabric loop attaches to the bottom of the booster and the red clip attaches to the shoulder belt above the shoulder.

How do locking clips work?

A locking clip works by clamping the lap and sash portion of the seat belt near the buckle to prevent slack and ensure a tight install. When installed properly, the seat should not be able to move more than a ½ inch to either side.

Can you install latch system in older car?

Cars made after 2002 have a LATCH (Lower Anchors and Tethers for CHildren) system in place from the factory, but there aren’t any kits available to retrofit older cars.

Do all car seats come with a locking clip?

Some car seats come with built-in locking clips called lock offs. If a seat has these, read the instruction manual on when to use them. Some require one, some two, some with the seat belt only, some all the time. These seats usually do not come with a separate locking clip.

Where are locking clips usually found?

The locking clip, placed on the webbing near the latchplate, is used to keep the belt tight. Since this eliminates the need to switch the belt to automatic locking retractor (ALR) mode, the shoulder belt doesn’t pull upward on one side of the base.

What type of car seat always requires a tether?

Vehicles model year 2000 and newer must have tether anchors in at least three backseat positions. In the backseat of vehicles with only one row of seats in the back (sedans, small SUV’s, hatchbacks, etc), all three positions in the backseat must have tether anchors.

Where should the retainer clip be on a car seat?

PLACEMENT OF CHILD IN SEAT The harness should be snug, and the retainer clip should be positioned at the level of the infant’s armpit, not on the abdomen or neck area.

What is the submarine effect?

In the “submarine effect” the body slides below the belt, acting like hinge. “Seatbelt syndrome” describes the presence of the seat belt sign plus an intra-abdominal or spinal injury.

What is the Exactus and how do I use it?

This can be useful when installing a child restraint and can result in a tighter fit. The Exactus is used in place of a gated buckle / double T fitting. Additionally, it can be used either on the buckle side of the belt, or the adjacent side. Because of this, it’s much easier to fit depending on your car seat position.

What is the Exactus used for on a belt?

What is the Exactus used for on a child restraint?

This can be useful when installing a child restraint and can result in a tighter fit. The Exactus is used in place of a gated buckle / double T fitting.

What is a gated buckle/locking clip?

What is a Gated Buckle / Locking Clip. A Gated Buckle is also called a Locking clip, which is used to help lock in the lateral tension to prevent lateral movement in case of a side impact with another object.