How to wire euroster Tx Rx 2006/2006tx?

EUROSTER 2006/2006TX – USER MANUAL 9 S2. Wiring example: EUROSTER TX RX connected to a gas-fired boiler Legend: 1. Terminal block 2. Two-conductor cable, voltage-free relay output of EUROSTER RX, normally open, contact rating: 5A, 230 V AC 3. Antenna 4. EUROSTER RX (receiver) 5. Euroster TX installed at a preferred location S3.

What is the power output of the euroster RX?

Euroster TX (transmitter unit) 8. Euroster RX (receiver unit) 9. Antenna 10.Terminal block 11.Two-conductor cable, voltage-free relay output of EUROSTER RX, normally open, contact rating: 5A, 230 V AC

How to fix the low battery lamp LED of euroster TX?

The low battery lamp LED will come on when the voltage has dropped below the minimum admissible level. Then the batteries must be replaced and EUROSTER TX must be programmed anew. B. First start-up 1. Insert new alkali batteries 2. Fully extend the telescopic antenna of the RX unit 3.

Why does my euroster TX turn off after 7 cycles?

If due to external interference such as strong electromagnetic pulse or low battery in EUROSTER TX confirmation of switch on/ off signal has not been received by EUROSTER RX for seven subsequent cycles the heating appliance will be switched off to prevent potential overheating.