What tools do I need to rebuild a differential?

Differential Repair Tools

1. Race Driver Sets.
2. Dial Indicators.
3. Dial Calipers.
4. Bearing Pullers & Adaptors.

What are the differential parts?

Components Of Differential

• Drive pinion or Bevel pinion.
• Ring gear or Crown wheel.
• Differential case.
• Differential side gear or Sun gears.
• Differential pinions or Planet gears.
• Axle shafts or Half shafts.
• Pinion shaft or Cross pin or spider.

What is standard differential?

A standard differential, or what is referred to as an open carrier, is what comes OEM on many vehicles. This is what holds the ring and pinion in place and gives the vehicle it’s final drive ratio. It is responsible for transmitting power from the driveshafts to the vehicles wheels to ultimatly make it move.

What type of differential do I have?

Differential Identification using Tags & Stampings The most accurate differential identification is provided by the bottom line of the tag number or axle tube stamp. Differential tags can easily be used to identify Dana and Ford differentials.

What happens if differential fails?

When a rear differential fails, it can cause vibration, noise and fluid leaks that impact a vehicle’s acceleration and driveability. A driver should consult a certified mechanic to deal with a bad rear differential and prevent further damage to the vehicle’s driving systems.

Are there any differential tools that make rear end work easier?

Here are some great Differential tools that make the job go much easier. Rear end work can be difficult with out the right tools. Take the strain off yourself, your pullers, and your new bearings by purchasing these toolbox gems, avaialble for most models.

What tools do I need to swap ring and pinion gears?

Differential tools are necessary for anyone working with ring and pinion setups, whether it is an experienced professional or the DIY enthusiast. Bearing pullers, dial indicators, brass punches, spanner wrenches…all of these specialty tools are required to swap ring and pinion gears and get them set up properly.

What tools do I need to change gears on a motorcycle?

Bearing pullers, dial indicators, brass punches, spanner wrenches…all of these specialty tools are required to swap ring and pinion gears and get them set up properly. There are also differential tools that make the job quicker and easier.

What are the different types of gear installer tools?

There are also differential tools that make the job quicker and easier. Complete Offroad manufactures the YT SA-01 Seal Press tool and the YT YH-01 Yoke Holder tool, both of which make the gear installer’s life better, and both of which are 100% USA made, assembled, and packaged.