How do you EQ a drum set?

How do you EQ a drum set?

EQ

  1. Remove any low-end rumble using a high-pass filter, up to 50 Hz depending on the mix.
  2. Boost the fundamental frequency of the kick, typically between 60 and 120 Hz (or cut if there’s too much)
  3. Remove any mud in the low-mids, typically around 250 Hz.

How do you EQ a live snare drum?

Start with rolling off the extreme lows so that the snare isn’t interfering with your kick and sub bass. Somewhere around 80hz should do the trick. Next add a gentle boost around 7kHz and high shelf around 12kHz to let the snare cut through. Lastly add a boost around 200-250hz for the body of the snare.

How do you EQ 808?

Here’s how:

  1. Add a compressor to the 808.
  2. Route the kick into its sidechain input.
  3. Set the attack to its fastest value, so that every time the kick hits, the 808 turns down momentarily. This will shave the transient off the 808.
  4. Adjust the release until the 808 returns naturally to full volume after the kick hits.

How do you EQ overhead drum mics?

4 Step Guide to EQing Your Overhead Mics

  1. Step 1 – Roll Off the Low End. The first step in EQing our overhead mics is to add a high pass filter.
  2. Step 2 – Cut the Boxiness of the Snare Drum.
  3. Step 3 – Reduce the Harshness of the Cymbals.
  4. Step 4 – Brighten your Cymbals Up.

Should you EQ snare?

If “harmonic” sounds are like colours, then “inharmonic” sounds are like “shades”. In other words, “inharmonic” sounds are quite dense, so they take up more room on the frequency-spectrum. This is why our snare drum will always require an EQ, regardless of how good it sounds.

What EQ frequency is snare drum?

A standard 14 inch snare drum can usually be tuned sound great at a fundamental frequency of 170 Hz and also tiger up at 200 Hz too. Thinner and lighter drumheads can be tuned to vibrate at higher frequencies, which is an acoustics principle that applies to guitar strings too.

How loud is a 808 mix?

around -18 dBFS
Instead of dressing up an 808 with half-a-dozen signal processors, just try making it louder than the other instruments. Start with all your faders down. Bring up the 808 so it’s at a reasonable level in your DAW (probably somewhere around -18 dBFS).