How do I configure ap9630?
By default, the APC AP9630 NMC (Network Management Card) does not have an IP address assigned. The easiest way to configure an IP address is to log into the UPS’s NMC over a serial port….Serial Access.
| Type | Device path |
|---|---|
| USB-Connected port 1 | /dev/ttyUSB0 |
| USB-Connected port 2 | /dev/ttyUSB1 |
How do I access APC UPS Web interface?
Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.
- Apply the port settings to establish the connection.
- Press enter 3-5 times to display the username prompt.
- Use the default username and password of “apc”.
How do I find my APC IP address?
On the LCD menu, access the About menu. On the About menu, select the SmartSlot Card option. Locate and access the IP address option. In our example, the LCD menu shows the APC UPS IP address 10.10.
What is the default password for Schneider Electric UPS?
apc
The default user name is device, and the default password is apc.
How do I reset my ap9630?
Hold the reset button for 5-7 seconds. Resets only the password. Hold the reset button for 20 seconds. This will restore the card to factory default settings including switching back to DHCP mode.
How do I set up UPS?
Configuring the UPS Settings
- Connect the UPS to the NAS using a USB cable.
- Select USB connection.
- Choose one of the following options.
- (Optional) Select Enable network UPS master and then specify the IP addresses to which QTS sends notifications in the event of power failure.
How do I restart my APC Network Management Card?
Press and hold the NMC’s pinhole reset button for 20+ seconds, ensuring the NMC’s status LED is pulsing green during this time. When it changes to amber or orange, release the reset button to let the format function complete and for the NMC to complete its reboot process.
Which devices can the AP9631 network management card be installed in?
The AP9631 Network Management Card includes all AP9630 Network Management Card features and the following: Devices in which you can install the Network Management Card 2. The NMC can be installed in: • Any Smart-UPS ® model that has an internal expansion slot, or any Symmetra ® UPS except the Symmetra PX 250 or Symmetra PX 500 UPS
Does the APC AP9630 NMC have an IP address assigned?
By default, the APC AP9630 NMC (Network Management Card) does not have an IP address assigned. The easiest way to configure an IP address is to log into the UPS’s NMC over a serial port. Many servers still come with a built-in 9-pin serial port, but most desktops and laptops do not. If you don’t have one, many vendors sell USB to serial adapters.
How do I configure an APC network management card?
An APC Network Management Card must be configured with network settings before it can communicate on the network. Once the cards have been configured with an IP address, Subnet Mask, and Default Gateway the cards can be accessed, managed, and controlled from other computers on the network.
How do I reset the user name and password on AP9606?
(*If you are using an AP9606, proceed to step 7.) Press the Reset button again a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc).