Can you make NPT threads in Solidworks?

Can you make NPT threads in Solidworks?

Luckily, the Hole Wizard feature inside of SOLIDWORKS already has the designated library of NPT sizes and we just need to look in the right place!

How do you create threads in Solidworks?

Start by creating a cylindrical extrusion or cylindrical hole, much like the initial steps to of making a cosmetic thread. The feature size should be the same as the nominal thread diameter. From there, select the starting edge. Then, click “Insert” then “Feature” and “Thread.” This will automatically create a thread.

What is the angle of NPT threads?

60°
NPT and NPS threads have a 60° included angle and have a Sellers thread form (flattened peaks and valleys). The trough between the trapezoidal threads is 1⁄8 of the pitch in width.

What is the taper on NPT threads?

Every NPT thread has a taper rate of ¾-inch per foot, or 1/16-inch per inch of length. The taper rate is determined by comparing the change in thread diameter over the length of the pipe. The taper angle itself Is 1° 47″ 24″” (1.7899°).

How do you create male threads in Solidworks?

Creating a Cut Thread

  1. Open a part file. The diameter of the cylinder is 6mm.
  2. Click Insert > Features > Thread .
  3. In the graphics area, select the top edge of the cylinder.
  4. In the PropertyManager, under Specification:
  5. Under Thread Location:
  6. Under End Condition, click Maintain Thread Length.
  7. Click .

How do you create assembly in Solidworks?

Creating an Assembly from a Part

  1. Click Make Assembly from Part/Assembly (Standard toolbar) or File > Make Assembly from Part. An assembly opens with the Insert Component PropertyManager active.
  2. Click in the graphics area to add the part to the assembly. SOLIDWORKS makes the first component fixed.

How do you make a tapped hole in Solidworks?

Create a part, select a surface, and click Hole Wizard (Features toolbar) or Insert > Features > Hole > Wizard . You can also open the Hole Wizard Type PropertyManager from an assembly.

How do you add threads in Solidworks 2020?

To create a cut thread:

  1. Open a model with a cylindrical part and click Insert > Features > Thread .
  2. In the graphics area, select a circular edge.
  3. In the PropertyManager, under Specification, set values for the following:
  4. For Thread method, click Cut thread.
  5. Set the starting position of the Thread Location: