Can you use EIGRP and OSPF?

In the implementation of summary functions, EIGRP can be implemented on any interface of any router, while OSPF can only be implemented on ABR and ASBR, and its route summary is not interface-based. 10. EIGRP supports load balancing of unequal path metrics, while OSPF only supports load balancing of equal metrics.

How does the EIGRP metric differ from the OSPF metric?

The EIGRP metric Is calculated based on bandwidth and delay. The OSPF metric is calculated on bandwidth only.

Why is OSPF preferred over EIGRP?

The scalability of the OSPF is higher than EIGRP because EIGRP is complicated and vendor-specific and incapable of migrating from one vendor to the other. Conversely, OSPF is an open standard and simple protocol through which the network can be scaled easily.

What is OSPF process ID?

The process ID is the ID of the OSPF process to which the interface belongs. The process ID is local to the router, and two OSPF neighboring routers can have different OSPF process IDs.

Which two commands are used to configure a basic OSPF configuration?

A number of different Cisco IOS OSPF configuration commands are available, but at its most basic, OSPF configuration uses three commands: the router ospf, network, and router-id commands. The router ospf process-id command is the beginning of any Cisco IOS OSPF configuration.

Does IPv6 redistribution EIGRP and OSPF?

For this configuration example, assume that EIGRP and OSPF routing for IPv6 has been configured correctly on all four routers. Enters IPv6 EIGRP configuration mode. Redistributes IPv6 routes from OSPF process ID 1 into EIGRP autonomous system 10 and assigns a seed metric to these routes.

How to run OSPF and EIGRP on the same router?

you need to configure one router to support both protocols i.e 1 interface of that router will run ospf and the other will interface will run eigrp and then you can redistribute between the two so both routing domains have each other networks if they need reachability. HTH.

What is the network configuration for OSPF and IGRP?

In the following configuration, OSPF is on network 172.16.0.0: In the following configuration, IGRP autonomous system 200 is on 192.0.2.1: router igrp 200 network 172.31.0.0 ! !

How do I configure OSPF on my Ethernet interface?

Configure address ranges for Ethernet interface 0 through Ethernet interface 3. Enable OSPF on each interface. Set up an OSPF authentication password for each area and network. Assign link-state metrics and other OSPF interface configuration options. Create a stub area with area ID 36.0.0.0.

What is an example of OSPF configuration?

Example: Basic OSPF Configuration for Internal Router ABR and ASBRs. The following example illustrates the assignment of four area IDs to four IP address ranges. In the example, OSPF routing process 109 is initialized, and four OSPF areas are defined: 10.9.50.0, 2, 3, and 0.