How do I connect my Arris SURFboard?
Connect the coaxial cable to the cable connector on the rear of your modem. Use your hand to align the threads and turn clockwise repeatedly to tighten the connector. Finally connect the power cord to the power port and plug it into a wall outlet. Make sure that the outlet is not controlled by a wall switch.
How do I connect my Arris surfboard modem?
How do I set up my surfboard SB6183?
To Install SB6183
- Connect one end of the coaxial cable to the cable outlet or splitter.
- Connect the other end of the coaxial cable to the cable connector on the SB6183.
- Plug the power cord into the power connector on the SB6183.
- Plug the power cord into the electrical outlet.
What do the lights on my Arris router mean?
There are 4-6 lights on each Arris modem, and each one gives you information about the status of your internet connection….How to Diagnose Wifi Troubles Using Arris Modem Lights.
| If You See… | That Means… |
|---|---|
| 2.4 GHz or 5 GHz Lights are Off | There is no device connected to the modem. |
How to set up an arris router?
– Click on the Wireless 5 GHz tab. – On the left side, click 5GHZ GUEST SSID. – Place a check in the box next to Enable Wireless. – In the Wireless Network Name (SSID) field, enter a new name. – In the Pre-Shared Key field, enter a new password. – Click Apply.
How do I manually configure my Arris cable modem?
– Model – Wi-Fi cable modem model name – SSID – Default network name for your Wi-Fi home network. – WI-FI SECURITY KEY – Wi-Fi network password to connect to your Wi-Fi home network. – S/N – Wi-Fi cable modem serial number. – HFC MAC ID – Your service provider may request the Media Access Control (MAC) number to activate your Wi-Fi cable modem.
How to set Arris modem to router mode?
a. Enter admin in the Username field. b. Enter password in the Password field. c. Click the Login button. The System Basic Setup page appears. Click the LAN Setup tab on the top menu. The LAN Settings page appears. On the LAN Settings page: a. NAT Mode – Click on the drop-down, and select Bridged. b. Click the Apply button.
How to setup your Arris SURFboard ripcurrent network?
– 2.4 GHz with 802.11n 2×2 antennas = 300 Mbps – 2.4 GHz with 802.11n 3×3 antennas = 450 Mbps – 2.4 GHz with 802.11ac 3×3 antennas = 600 Mbps – 5 GHz with 802.11ac 2×2 antennas = 900 Mbps – 5 GHz with 802-11ac 3×3 antennas = 1300 Mbps