How to fix PXE E53 error?

To resolve this issue, correct the DHCP relay agent configuration. 3. The DHCP server resides in a different network from the PXE client, but the IP Helper is mis-configured. Verify the IP Helper settings and that the PXE Server recevies requests from the client (via the pxe.

Table of Contents

How do I disable PXE?

To disable PXE boot, the steps are as follows:

Enter “Setup” once the computer is turned on.
Click on the Advanced tab and locate the “Integrated Devices” option.
Find the “Network Interface Controller” option.
Set it to “On” instead of “On with PXE” to disable PXE.
This disables PXE.

Why is my computer doing a PXE boot?

Preboot Execution Environment (PXE) errors occur when the system BIOS cannot boot to the system’s hard disk drive or a network boot environment.

Why am I getting an E53 error during PXE?

The basic PXE process starts with a DHCP request which is expecting responses that include 1) an IP address for the booting system, 2) the address of the PXE server and 3) the name of the .0 or .efi file (the PXE boot menu). If only #1 is returned and not 2,3, an E53 error is displayed. Following are some possible reasons this might happen.

How do I get a PXE boot menu?

The client computer requested a PXE boot menu and did not receive sufficient instructions on how to get one. The basic PXE process starts with a DHCP request which is expecting responses that include 1) an IP address for the booting system, 2) the address of the PXE server and 3) the name of the .0 or .efi file (the PXE boot menu).

How do I open the PXE server configuration utility?

Open the PXE Configuration Utility and select the “PXE Server” tab on Deployment Solution 6.5+, and “General” on previous versions. The following screenshot is from PXE 6.5.