What are the standard size sockets?
Therefore, it’s important to choose the precise socket size that fits the particular fastener. There are four common socket sizes: 1/4 inch (0.6 centimeters), 3/8 inch (0.9 centimeters), 1/2 inch (1.3 centimeters) and 3/4 inch (1.9 centimeters).
How can you tell the size of a socket?
How to Determine the Right Size Socket for a Nut
- Turn on the digital caliper and set it to read in inches, not millimeters.
- Close the caliper jaws until each jaw rests on one flat side of the nut on opposite sides.
- Check the caliper display.
- Turn on the digital caliper and set it to read in millimeters, not inches.
What are the different sizes of socket drivers?
These drive fittings come in four common sizes: 1⁄4 inch, 3⁄8 inch, 1⁄2 inch, and 3⁄4 inch (referred to as “drives”, as in ” 3⁄8 drive”).
What’s smaller than a 11/16 socket?
Standard Combination Wrenches (1/4, 5/16, 11/32, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 13/16, 7/8, 15/16, 1)
How are 12 sockets measured?
In the current market, socket sizes are divided into two systems: SAE (imperial, measured in inches) and metric (measured in millimeters). Both 6-point and 12-point sockets are measured using these two systems. The popular range is 5.5~24mm.
What’s better 12 point or 6 point sockets?
Answer: It’s true that 12-point sockets are fine for most lightweight repairs, but heavy wrenching calls for a six-point socket. A six-point socket is much less likely to slip off a stubborn fastener or round over the corners. Here’s why: (1) Six-point sockets have thicker walls, so they’re less likely to flew.
Which is bigger 5/16 or 8mm?
8mm = 5/16 inch.
What are the standard socket sizes in proper order?
Standard Socket Sizes. Other than these,there are also certain in-between socket sizes that start with ¼ inch (0.6 cm) and increase every sixteenth of an individual inch (0.16 centimeters).
What size is a standard socket set?
Standard Socket Sizes Four of the most common socket drive sizes and the typical range of applicable socket sizes 1/4 inch drive (0.6 centimeters)- Works with 4mm to ( 4.5 mm, 5mm, 5.5 mm, 6 mm, 7 mm, 8 mm, 9 mm, 10 mm, 11 mm, 12 mm, 13 mm, 14 mm) 15 mm sockets. 3/8 inch drive (0.9 centimeters) – Works with 5.5 mm to 22 mm sockets.
What size socket do I Need?
– Shallow length sockets: These are helpful for tight spaces that can be tough to operate in. – Standard length sockets (intermediate): These are best for most basic projects that you’ll take on. – Deep sockets: A deep socket can help you reach bolts that are far down in a vehicle or piece of machinery that you’re working on.
What size socket or wrench is needed?
You at least need a set of 3/8″ (drive size) sockets set with sizes 8-19mm. Some vehicles use Allen or Torx bits for the caliper guide pins. Torx and Allen bits are not interchangeable. The wrong bit may feel like it fits, but it might damage the female head of the bolt.