What is the difference between alodine 1200 and 1201?

Alodine 1200 is intended as an immersion treatment. Controlled in a bath at elevated temperatures. Alodine 1201 is a brush application treatment.

How do you apply alodine 1200S?

Apply the diluted ALODINE 1200S coating chemical solution liberally to the aluminum surface. Treat at one time only as large an area as can be conveniently handled with the equipment being used (approximately 6 to 10 square feet of surface).

What color is Alodine 1200?

coating on aluminum which ranges in color from light iridescent golden to tan. The process is operated at room temperature. The coating produced minimizes corrosion and provides an improved bond for paint. Alodine® 1200 is used in an immersion, spray and brush-on application.

How do you mix Bonderite M Cr 1200S?

Mix 2 oz. of BONDERITE M-CR 1200S AERO (known as ALODINE 1200S) coating chemical per gallon of water (this is equivalent to 15 g of BONDERITE M-CR 1200S AERO (known as ALODINE 1200S) coating chemical per liter of solution). Stir well until the powder is dissolved.

How long does alodine last?

Alodining is a process in which a metal is coated with a chemical called alodine. This coating hardens to the surface and can last for years if painted, not requiring reapplication.

Is alodine 1200 conductive?

Alodine 1200S conforms to MIL-C-5541E Class 1A and 3 coatings, Methods A, B & C application. Alodine coatings are electrically conductive.

How do you apply Alocrom 1200?

Brush Alocrom mixture should always be applied quickly, liberally and evenly working upwards on vertical surfaces. Do not attempt to treat very large areas at one time. A nylon brush is normally effective; other soft bristle or sponges can be used for specific purposes.

What is the difference between alodine 600 and 1200?

The primary difference in the two chemicals is the issue of coating weight. The Alodine 1200 will produce a heavier film than the 600 will. The Aerospace industry uses the 600 chemical on areas that require electrical bonding.

How do you use Bonderite?

Activate by holding the applicator tip down on the surface to be treated. Press the pen tip down for 15 to 30 seconds to open the spring valve allowing BONDERITE M-CR 1132 AERO to wet the applicator tip. When the BONDERITE M-CR 1132 AERO just wets the tip, release the downward pressure. The unit is ready to use.