How do I uninstall ProClip?

How do I uninstall ProClip?

Taking your device in and out of its ProClip holder is pretty quick and simple. Just slide it in when you get into the car and easily slide it out when you arrive at your destination.

What are Proclips made of?

ProClip parts are machined and hand-tooled in Sweden from high-quality ABS and Acetal plastic – not mass produced with injection molding. The ProClip phone mounting solution consists of two separate parts: the exact-fit vehicle mounting base and a phone holder made specifically for your phone.

How do I adjust my ProClip phone holder?

Loosen the screws above and below the center hole to release the side arms. Dock your phone with protective case in the holder grooves to adjust for correct width. After sizing for correct width, tighten same screws to lock arms in place. (DO NOT fully remove these screws).

How do I use ProClip in brodit?

Set up the Brodit phone mount and ProClip in 6 steps

  1. Step 1: gather the necessary items.
  2. Step 2: detach the back side of the phone mount.
  3. Step 3: attach the back on the ProClip.
  4. Step 4: adjust the width of the Brodit phone mount.
  5. Step 5: adjust the front side of the phone mount.
  6. Step 6: place the ProClip in your car.

How do I adjust my proclip phone holder?

Where is ProClip made?

Karlsborg, Sweden
ProClip products are manufactured in Karlsborg, Sweden by Brodit AB, a company that was established in 1983 to provide communication device mounting solutions for in-vehicle use.

Are magnetic phone mounts safe?

Therefore, the magnetic mount will not have a negative impact. But, if you have some kind of compass on your device that depends on magnetic north/south, there would be a negative impact, but overall magnetic mounting devices are very safe for the latest mobile devices.

How do you fit a Brodit phone?

You can adjust the Brodit phone mount exactly to the width of your device, including the case. To do this, unscrew the 2 small screws at the top and bottom until you can adjust the mount. Place your phone in the mount, press the sides firmly, and then tighten the screws.