How do I fix the F1 on my Fisher and Paykel dishwasher?
- Locate the drain-access filter panel on the bottom of the drawer.
- Remove the rack that sits above it.
- Pull up to lift the drain filter and remove it from the machine.
- Set the filter under the faucet to rinse it clean with cold water.
- Reinstall the filter and confirm that it sits flush with the bottom of the DishDrawer.
How do you reset the code on a Fisher and Paykel dishwasher?
Reset Procedures for the Fisher & Paykel Dishwasher
- Press the power button to turn off power to the Fisher & Paykel dishwasher.
- Wait a few minutes and then press the power button to restore power.
- Turn off and unplug the dishwasher if the issue remains.
- Wait five minutes and restore power to the unit.
What does F mean on a dishwasher?
Flood switch activated. Turn the dishwasher OFF and ON again. If fault persists, turn water off and disconnect the dishwasher from the power supply.
What does A1 mean on Fisher Paykel dishwasher?
No water supply
Check for a kinked drain hose, blocked waste connection, highloop not properly installed, drain hose not routed correctly or spray arms not in place. No water supply. ( This is displayed as an A1 fault) Check water is connected and turned on. The dishwasher is beeping continuously.
What does F1 error mean?
F1 Error. The F1 error means that there is an electronics failure within the oven. This failure can occur within the keypad itself, the electronic oven control or the oven temperature sensor.
What does F1 mean on a sharp dishwasher?
F1: Sharp dishwasher F1 error indicates that the alarm is active against water overflow.
How do you unlock a Fisher Paykel dishwasher?
Closed drawer auto-lock is on This keeps the drawer locked even after your DishDrawer™ has powered off. Unlock by powering your DishDrawer™ back on (unless Keylock is activated, see above). Press any button and open drawer within 30 seconds.
How do I unlock Fisher and Paykel DishDrawer?
To use the Key Lock mode: button for 3 seconds to lock or unlock the control panel.
What does F1 mean on a Whirlpool dishwasher?
Temperature sensor
F1 (or 1 flash) – Temperature sensor. The temperature sensor in your machine has detected the water temperature is too low (below -3°C) or too high (above 85°C).
What does e1 F1 mean on Whirlpool dishwasher?
1-1 (F1E1) – A stuck relay indication is the culprit, but don’t assume the board is bad. They’re expensive and a few minutes with a flashlight, good eyes, and a meter might save some big money. Use the tech sheet behind the toe-kick of the dishwasher as a guide.
How do I fix e30 error on dishwasher?
Lower the appliance to the floor and reconnect it. Check the water supply and drainage. Check if the filters in the inlet hose and water valve are clean (where the inlet hose is screwed onto the appliance and at the water tap). Start a wash cycle and see whether the problem has been resolved.
What does U6 mean on a Fisher & Paykel dishwasher?
How to attend to a fault – Classic models
| Fault Code | Possible Cause of Fault |
|---|---|
| U4 | Fault in the other drawer preventing the use of this drawer. |
| U6 | The spray arm has loosened or come off its mounting, or water pressure is too low. |
| E1 | Flood detected. |
| E2 | Motor fault. |