How do I fix unsupported video configuration detected?
Shut down the computer. Plug the monitor cable into the add-in graphics card connector. This may require a video adapter or video adapter cable….My solution was:
- press F2.
- and then in the video option select the default option.
- and then press F2 again,
- then video option and the option to connect to 2 monitor and apply.
What does unsupported video configuration mean?
There can be more than one VGA socket on the back of a PC and the “Unsupported Video Configuration Detected” message is shown when the monitor is plugged into the wrong one.
How do I uninstall and install a graphics card?
Once the graphics card is disconnected from the case itself, the card will still be slotted into a PCIe slot. Looking down at where the card is slotted into the motherboard, there will be a small clip holding the card in place to the motherboard. Push down on the clip to release the card.
How do I remove a Dell GPU?
Steps
- Lay the computer on the right side.
- Locate the graphics card (PCI-Express).
- Disconnect the power cables from the graphics card and remove them from the routing guides on the graphics -card support bracket.
- Push the securing tabs on the graphics-card support bracket and rotate to remove it off the chassis.
How do I remove the graphics card from my Dell Optiplex?
- Pre-Removal Instructions Before removing the First Removal:
- Establishing image. Press the release tab on the card retention latch from the inside to pivot the latch open. Pull the retention tab away from the expansion card. Lift the expansion card up and out of the expansion slot. Complete. Back to Top.
Why is my graphics card not coming out?
Sometimes the ‘Graphics card not detected’ error will occur upon the installation of new drivers if something goes wrong. This could be a faulty driver or the new drivers’ incompatibility with another component inside the PC; the options are too numerous to list.
Where do I find my graphics card info?
How can I find out which graphics card I have in my PC?
- Click Start.
- On the Start menu, click Run.
- In the Open box, type “dxdiag” (without the quotation marks), and then click OK.
- The DirectX Diagnostic Tool opens.
- On the Display tab, information about your graphics card is shown in the Device section.
https://www.youtube.com/watch?v=MssKEgbcBkQ