How do I sync my iHome alarm clock?

You can pair your iHome Speaker with an Android device by going to Settings -> Go to Connections -> Press Bluetooth. You should now see the iDM12 icon on your Android device. You can pair it by pressing it.

How do I connect my iHome Bluetooth?

Pairing your iHome Speaker with an Android Device Go to Settings –>> Go to Connections –>> Press Bluetooth to turn on. Go back to your Android device and you should now see iDM12 on the screen. Press it to pair.

How do I reset my iHome clock?

To do so, turn the unit ON and press the end of paperclip or similar into the reset port on the back of the unit for less than 2 seconds to reset it without clearing Bluetooth settings. The unit will reset and power back on. (If pressed for longer than 2 seconds, the unit will reset but will not power back on.)

How do I turn my iHome clock on?

Connect one end of the included standard stereo 3.5mm audio cable into the aux-in jack on the back of the unit and the other end into the headphone or output jack of your audio device. 2. Press the Power/Alarm Reset Button on the unit to turn it on.

How do I change iHome settings?

Press and release the Mode Button as needed until the current FM radio station appears on the display. 2. Press and release the /Presets Button as needed until the preset number (P1- P6) you wish to sets is displayed, then press and hold the /Presets Button to enter setting mode. One beep will sound.

Where is the pairing button on my iHome?

Where Is The Pairing Button On My Ihome? Make your device “discoverable” by turning it on Bluetooth connectivity. The Play/Pause/Pairing Button is located on top of the unit. Press and hold it to pair the iDM12 (release the amber light on the iDM12 and 2 beeps sound).

How does the iHome clock work?

Press and hold the Time Set/Sleep Button for 2 seconds until the clock display flashes and a beep sounds. 2. Press the or Buttons to adjust the clock to the current time (hold for rapid setting). Make sure you set the correct AM/PM time.

Why is my iHome vacuum not working?

Reset your iHome unit Leave the unit for about 15 minutes to ensure that all electronic charges have dissipated from the unit. Replace batteries and reconnect to power source. For units with a reset port or button, press the reset button or insert a paper clip or similar into the reset port then release/remove.

How do you use the iHome clock?

Press and hold the Time Set Button located on the back of the unit for 2 seconds until the clock display flashes and a beep sounds. 2. Press the – or + Buttons to adjust the clock to the current time (hold for rapid setting). Make sure you set the correct AM/PM time.