How do I test my Alltrax controller?
Alltrax SPM, SPB, AXE & NPX controllers, measure the voltage between the two throttle pins (see pictures below) with the key on and the peddle depress just enough to active at the foot switch. You should hear the solenoid close at this time and have a lit LED light. You should see 10 volts on the throttle pins.
How do you test a 48 volt solenoid on a golf cart?
Set your multimeter to ohms and insert a probe on each large terminal with the key off and the cart direction switch in the neutral position. Press on the accelerator with the cart’s movement control in the forward position, and the key is turned on. A click should be heard first from the solenoid.
What are the symptoms of a bad solenoid in a golf cart?
On an electric golf cart, the most common symptom is the solenoid is not delivering electricity to the controller when the vehicle’s ignition is turned on. In normal operating conditions, the solenoid clicks on and off with the ignition switch. A failing solenoid will generally not click.
How do I reset my golf cart computer?
Easily Reset the Club Car Golf Cart OBC
- Key switch to off.
- Set forward/reverse to neutral.
- Put tow/run switch to tow.
- Disconnect the negative battery terminal from the battery pack.
- Put the tow/run switch to run.
- Put forward/reverse switch to reverse.
- Put key switch to on.
How do you test a speed controller on a golf cart?
Connect the negative probe to the controller’s M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor.
How do I know if my motor controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
How does the Alltrax controller work?
This is a voltage system where the controller puts out the base throttle voltage and the pedal induction device (under the floor) reduces the signal voltage more and more as the pedal is depressed. This device is also subject to interference by water, see hair dyer tip above. Below is the test procedures and results for all Alltrax controllers.
How do I test the throttle on my Alltrax?
Press the Pedal down to the floor, full throttle and you should see 6 volts. Alltrax SPM, SPB, AXE & NPX controllers, measure the voltage between the two throttle pins (see pictures below) with the key on and the peddle depress just enough to active at the foot switch. You should hear the solenoid close at this time and have a lit LED light.
How do I measure the pins on my Alltrax controller?
Alltrax DCX & NCX controllers, you need to pull the 10 or 6 pin connector back just enough to expose the pins to measure them. Make sure not to short any of the pins.